Cub Cadet FT24 Manual Del Operador página 12

Cultivating Procedures
For cultivating, a two to three inch depth is desirable. The tine
width can be reduced to 13 inches by removing the outer tines
completely from the tiller. See the Maintenance & Adjustments
Section for instructions on removing the tines.
When laying out plant rows, be sure to allow enough width to
permit cultivation between the rows. In growing corn or similar
crops, check-row planting will permit cross cultivation and
practically eliminate hand hoeing. See Fig. 5-5.
Figure 5-5
Other Uses
The tiller has many uses other than tilling and cultivating a
garden. One of these is the preparation of lawn area for seeding.
The tiller will prepare a deep seed bed which will be free of hard
untilled spots, allowing a better stand of grass to grow. The tiller
is very useful for loosening hard soil for excavation with a shovel;
No tedious handwork will be necessary. Your tiller may be used
for mixing compost in the pile or for mixing it with the soil in
your garden. This should be done after the soil has been broken
to the full working depth. The compost should be worked in
to a depth of six to seven inches. This may be done by working
the length of the garden and then by making separate passes
across its width. The addition of decayed organic matter will
substantially increase the fertility of your garden. For proper
decaying action, fertilizer should be applied and worked in with
the mulch materials. Breaking up leaves and straw and mixing
it with several inches of soil allows proper aeration of the plant
root system and retards the growth of weeds.
12 s 5— O
ectiOn peratiOn