Craftmade Ellington E-WOD52ABZ5C Guia De Instalacion página 5

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4in. downrod provided to use with an
extended downrod (sold separately). [If you wish
to use the 4in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from motor housing
yoke. Slide downrod through canopy and
weatherproof yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the
downrod.
Thread downrod into the motor yoke until holes
for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip. Tighten yoke set screws and nut
securely. Lower weatherproof yoke cover to motor
housing.
Remove electrical tape from electrical wiring and
thread one wire through each hole in the
weatherproof hanging ball cover. Pull
weatherproof hanging ball cover down securely
over hanging ball (on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
hanging
ball
clip
page 4
set screw hole
stop pin
hanging ball
B
weatherproof hanging
ball cover
downrod
canopy
weatherproof
yoke cover
yoke set screw
pin
motor
housing