Description Of Parts - Bigben R70P Modo De Empleo

Description of Parts

1) Main Display
2) Snooze | Dimmer
3) Alarm 1
4) Alarm 2
5) Clock setup
6) Projection ON / OFF
7) Hour Selection
8) Minute Selection
9) Volume control "-"
10) Volume control "+"
11) Projection focus
12) One key projection reverse
13) Melody selection
FEATURES DESCRIPTION
1) Setup device
When the unit is powered up first time, the display shows only main 3 digits [0:00] and the clock starts
running from 0:00:0
2) Set the clock
• Press [5] and hold for 2 seconds when the unit is in standby mode, [24 H] appears on the display
and the first 2 digits will start flashing.
• Press [10] button to select 12 [12 H] or 24 [24 H] hour clock format.
• When the selection of clock format is done, press [5] key again. The main digit of display will start
flashing.
• Press [7] and [8] button to adjust Hour's value and Minute's value, then press [5] once to confirm
when it is done.
• Now the seconds icon will reset to beginning of the minute and the clock will start running.
3) Set alarm
• When the device is in standby, press [3] and hold for 3 seconds until the main digit with alarm 1
icon of the display starts flashing.
• Press [7] and [8] buttons to adjust Hour's value and Minute's value for alarm 1, then press [3] once
to confirm when it is done. Then the melody icon
• Press [9] and [10] buttons to adjust the melody that will play when alarm 1 is active. Press [3] again
to select output level of the alarm. The Volume indicator
• Press [7] and [8] buttons to adjust the level for alarm output, then press [3] to confirm and exit alarm
1 setup.
• Repeat the same as above to setup Alarm 2.
4) How to use projection
• Press [6] once to turn on projection and press once again to turn it off.
will appear for melody selection.
appear on lower right side.
- EN 3 -