Casals REINTAIR S 300 AC Manual De Uso Y Mantenimiento página 44

REG REINTAIR
Purifier control with fan EC 0... 10V and UV-C lamp
PUSH BUTTONS
The regulator has 4 buttons: ON / OFF, MODE, UP and DOWN.
Note: If the backlight is off, the first press (on any button) turns the backlight on. With the backlight on, the functions of the buttons are as described
below. The backlight automatically turns off after 2 minutes without pressing.
Basic functions:
ON / OFF:
Short press: Selects the regulator on / off status. Manual mode.
Long press (approx 1s): Activates and deactivates the time programming.
Schedule off: Manual mode
Schedule activated: Schedule mode.
MODE:
Short press: Display of operating times (filters G4 and H14).
Long press (2s approx): Access the user menu:
Date setting (HOrA)
Schedule Settings (PrOG)
Identifier display (id)
Parameter mode (PAr)
Reset of filter operating time G4 (r g4)
Reset del tiempo de funcionamiento filtro H14 (r h 14)
Regulator reset (rESET).
GO UP:
Short / long press: Increase the speed setpoint (0% ... 100%).
GO DOWN:
Short / long press: Decrease the speed setpoint (100% ... 0%).
Note: If MODE + UP is pressed continuously when powering the regulator, or after a reset, it returns to the values default (showing on screen dEFEC).
User Menu:
- User Menu: With UP and DOWN you select the mode to access. To enter the selected mode, press MODE. To exit press ON / OFF.
- Date setting (HOrA): With MODE the data to be modified (day / time) is selected and with UP and DOWN the value is modified. ON / OFF
exits the date setting and returns to normal operating mode.
-Schedule settings (PrOG): With MODE the data to be modified (day / period / setpoint) is selected, and with UP and DOWN the correspon-
ding value is modified (time / setpoint). To deactivate the period, set the time to value: -. ON / OFF exits the time schedule configuration,
returning to normal operating mode. See the REG REINTAIR regulator time schedule.
- Identifier display (ıd): The identifier configured in the regulator is displayed through serial communication.
- Parameter mode (PAr): With MODE the parameter to be displayed is selected, and with UP and DOWN its value is modified. With ON / OFF
the parameter mode is exited, returning to the normal operating mode. See REG REINTAIR regulator parameters.
CV05_2020-Rev.01
REG REINTAIR
The display is made by 5 digits of 7 segments: O 1 2 3 4 5 6 7 8 9 A b C d E F
D1 D2 D3 D4 D5
REINTAIR
88888
20