Casals REINTAIR S 300 AC Manual De Uso Y Mantenimiento página 45

- Reset of filter G4 operating time (r g4): When entering this mode, the current operating hours of the G4 filter are displayed. To reset the
operating time (for example, resetting the hours by changing the filter), press ON / OFF. As confirmation of the reset of the operating time,
the display shows "HG OOOOO", returning to the normal operating mode. If ON / OFF is not pressed, after a few seconds the regulator returns
to normal operating mode without having reset the operating time.
- Reset del tiempo de funcionamiento del filtro H14 (r H 14): Upon entering this mode, the current operating hours of the H14 filter are
displayed. To reset the operating time (for example, resetting the hours by changing the filter), press ON / OFF. As confirmation of the reset
of the operating time, the display shows "HH OOOOO", returning to the normal operating mode. If ON / OFF is not pressed, after a few seconds
the regulator returns to normal operating mode without having reset the operating time.
- Controller reset (rESET): When the regulator is reset, the display shows "-----", starting operation again after a few seconds.
DISPLAY LCD
Note: When powering the regulator, or after resetting it, it displays the following on the display:
• rP143 + : REG REINTAIR regulator indication
• v X.X: Indication of the controller firmware version.
• wAit: Indication that the regulator is in the initialization process
ICON
CV05_2020-Rev.01
INDICATION
Fan status:
- Fan off: Icon off.
- Fan on: Icon on.
G4 filter status (1): + 1
- Clean filter: Icon off.
- Dirty filter: Icon on.
H14 filter status (2): + 2
- Clean filter: Icon off.
- Dirty filter: Icon on.
Fan speed setpoint:
Selection range: 0% ... 100%. Display: 0% ... 99%, 100% = HIGH
= 0%: Fan off.
> 0%: Fan on.
O ... 99 ... H
1
With regulator off in manual mode, these digits remain off.
In parameter mode it indicates the parameter number.
21