Water Cut-Off Warning; Overflowing Warning - Fulgor Milano F6DWT24SS2 Manual De Usuario

End of Program indicator will light up
when the washing program is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the
socket.
C
For energy saving, the
machine is automatically
turned off following the
completion of the program or
if the program is not started.
C
Leave your dishes in the
machine for about 15
minutes to allow them cool
down after they are washed.
Your dishes will dry in a
shorter time if you leave
the door of your machine
ajar during this period. This
process will increase the
drying effectiveness of your
machine.
6.11 WATER CUT-OFF
WARNING
If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and E:02 icon will flash
on the program indicator. As long
as the problem continues, washing
program is paused and the water inlet
is checked regularly by the machine;
when the water is restored E:02 icon
will disappear after a while and the
washing program resumes.
6.12 OVERFLOWING
WARNING
If the machine intakes too much
water or there is leakage at any of the
components then the machine will
detect this and E:01 icon will flash on
the Program indicator. As long as the
overflowing continues safety algorithm
will be active and try to discharge the
water. If overflowing stops and safety
is assured, E:01 icon will disappear.
If E:01 does not disappear, there
is a permanent fault. In this case
the authorised service should be
contacted.
ProCare
This program is recommended to
be operated on each 1-2 months for
machine cleaning and necessary
hygiene. The program should be
operated while the machine is empty.
In order to achieve an efficient result, it
is recommended to use together with
special machine cleaning agents.
C
Do not use this program to
clean dishes. As it operates
in high temperatures, it is
harmful for the dishes.
26
USA