Before Using For The First Time - Oster Press X press GCSTSG1200 Manual De Instrucciones

BEFORE USING FOR THE FIRST TIME

Warning: Remove all packaging including any soleplate protection before
operating your steam generator.
1. Wipe over the soleplate with a soft cloth.
2. Position the iron handset (3) on the base station (10), on your ironing board (if it is
large enough) or on a heat resistant and secure surface at the same height as your
ironing board.
3. Before connecting your steam generator to the mains supply, make sure your supply
voltage is the same as the one indicated on your steam generator.
4. W hen you first use your steam generator, there may be a slight odour and it may
smoke slightly for the first few minutes of operation. This is quite normal and will
disappear.
MPORTANT: On first use the water system will need priming before the handset will
create steam. It is necessary to operate the steam boost function a few times before the
unit will be ready to create steam. To operate the steam boost function, double-click the
steam trigger (4) quickly.
CLEANING YOUR STEAM
GENERATOR BEFORE USE
Follow these simple steps to remove any impurities or residues inside your steam
generator that may be left over from the manufacturing process.
1. F ollow the instructions under filling your steam generator and fill the water tank (8) as
described.
2. Empty the water tank to rinse out any foreign particles then refill it.
3. F ollow the instructions under steam ironing. Set the temperature to the MAX setting (5)
4. Iron an old piece of cloth (cotton or towels is ideal) for a few minutes. While ironing,
press the steam trigger (4) 4 or 5 times. Upon first usage the pump will need priming
and you may need to hold the steam trigger to pull water through the system and
create steam.
5. A ny impurities will be flushed from your iron by the steam and absorbed by the cloth.
Your iron is now ready for use.
FILLING YOUR STEAM GENERATOR
1. Remove the water tank (8) by holding the handle and pulling the tank forwards from the
base station (10).
2. Slide the water tank out.
3. F ill the water tank with cold tap water to the MAX mark.
4. Slide the water tank back into the base unit until it latches securely into place. You
should hear an audible click.
E n g li sh -4