Before First Use; Filling With Water - Oster GCSTBS6001 Manual De Instrucciones

• When using the Iron for the first time, test it on a piece of old cloth to be sure that the
Soleplate and the Water reservoir are clean.
• It is possible that the Iron will discharge some smoke or give off a slight odor during it
is first usage . This is due to the initial heating of the materials used. This is completely
normal and will stop shortly afterwards,
• When not ironing, always have the Steam Select Switch turned to the close position
CHOOSING THE RIGHT WATER
• This Steam iron May be used by normal tap water. However, if the water if the region in
which you live is especially hard, it is recommended to use distilled water to prolong the
life of your iron.
• Do not use that has been desalinated with chemicals.
1. Turn off the Iron and disconnect the plug from the
electrical wall outlet before filling the Iron with water.
2. Turn the Steam Select Switch to the closed position
3. Set the Iron in the position indicated below (figure 2)
and fill it with water, no higher than the Max fill level
shown on the See-Through Water Window.
GCSTBS6001_GCSTBS6002_GCSTBS6005_GCSTBS6051_GCSTBS6052_SEM1 (LA).indd 4

BEFORE FIRST USE

INSTRUCTIONS FOR USE

FILLING WITH WATER

E n g li sh -4
figure 2
.
.
5/19/20 6:13 PM