Setup Menu - DeFelsko PosiTector RTR 3D Manual De Instrucciones

OFF, the PosiTector RTR 3D will measure all grades of replica
tape just like a conventional spring micrometer.
Linearize
n When the Linearize box IS checked, the PosiTector RTR 3D
displays a more accurate peak-to-valley height measurement H
has been adjusted for the non-linearity of replica tape. There is no
need to average 2 or more replicas from different grades of tape AND
there is no need to subtract the 50.8 µm (2 mils) of incompressible
polyester film. Ensure the proper tape grade, C or XC, has been
selected (pg. 8) and appears in the upper left corner of the display.
n When the Linearize box is NOT checked, the PosiTector RTR 3D
displays a height value of H comparable to the value an analog
spring micrometer would display after the 50.8 µm (2 mils) of
incompressible polyester film has been subtracted. In other words, it
is the average of the maximum peak-to-valley distances obtained by
measuring the thickness of the replica tape without any correction.
During measurement, if the linearized measurement falls outside of
the selected tape grade's range, the Gage will suggest a more
suitable tape grade to perform the measurement.
Units
Converts the display from thou/mils to microns and vice versa.
Reset
Reset (menu reset) restores factory settings and returns the Gage to
a known condition. The following occurs:
- All batches, batch names, and screen captures are erased.
- Menu settings are returned to the following:
Memory = OFF
Statistics = OFF
Display = None
Auto Dim = ON
Tape Grade = XC
Linearize = ON

Setup Menu

2D = ON
3D = ON
Bluetooth & Stream = OFF
WiFi & Access Point = OFF
USB Keyboard & Stream = OFF
BLE Keyboard = OFF
9
that
L