Quick Start - DeFelsko PosiTector RTR 3D Manual De Instrucciones

The PosiTector RTR 3D Replica Tape Reader is a hand-held
electronic instrument that measures burnished Testex Press-O-
Film replica tape and uses a light intensity versus thickness
TM
algorithm to produce three-dimensional (3D) images of the replicated
surface. Images generated within the gage are analyzed to produce
2D and 3D parameters that represent specific characteristics of a
surface.
Press the button to power up the Gage. To conserve battery life,
the gage will automatically go to sleep after 5 minutes of inactivity.
While in Sleep Mode, the gage powers up significantly faster—
convenient when moving between parts or locations. The gage will
completely power off after 4 hours of inactivity. Alternatively, select
Power Off from the main menu. All settings are retained.
With the Gage powered down...
1. Clean the probe with included cleaning card and microfiber
cloth (pg. 7).
2. Power-up Gage by pressing the center
3. Zero the probe (pg. 8).
4. Verify Gage accuracy (pg. 7).
5. Measure the burnished replica tape (pg. 4).
NOTE:
To ensure best accuracy, the user will be prompted to zero
the probe every time the Gage is powered-up. It is therefore good
practice to clean the probe regularly with the included cleaning card
and microfiber cloth. Cleaning is best performed when the Gage is
powered down.
Tape Grade
Coarse (C)
X-Coarse (XC)
Optical Grade
Coarse (C)
Optical Grade
X-Coarse (XC)
Introduction

Quick Start

Tape Selection (pg. 8)
Height Measurement
button.
2D/3D Parameters
1