Anti-Shock Protection; Hold Function - auna CDC-200 Manual De Instrucciones

EN
30
Program operation
This function allows the tracks to be played in a programmed sequence.
Programs can be set in STOP mode.
1. Tap the PLAY MODE button once. The MEM. indicator will flash and
Program Channel Number "P01" will appear and the track number "001"
will blink on the LCD DISPLAY to prompt for input.
2. Tap the NEXT/PREVIOUS buttons repeatedly to select the track to be
programmed.(For a MP3 CD, the folder number will show on the LCD
DISPLAY)
3. Tap the PLAY MODE button again to store selection. The Program
Channel No. will change to "002" and the track number "002" will blink
to prompt for input
4. You may repeat steps 2 - 3 to program as many as 24 tracks. (For a MP3
CD, you may repeat steps 2 - 3 to program as many as 99 tracks.)
5. Tap PLAY/PAUSE button to start the programmed play
6. You may repeat the current programmed track or all programmed tracks
by pressing the PLAY MODE button once or twice at programmed play
mode.
7. Tap STOP button once to stop playback.
8. Tap PLAY/PAUSE button to resume programmed play.
9. To cancel programmed play and, press the STOP button twice.

Anti-shock protection

This player incorporates an electronic anti-skip circuit to prevent
interruption of the sound output when the unit is subjecting to shock,
vibration or rolling during CD playback.
Once anti-skip buffer is full, it will give you approximately 60 seconds of
protection against interruption of sound output. If the player is subjected
to shock or rolling for longer than the buffer memory, some interruption
of sound output will occur. This is normal and to be expected and the
sound will resume once the player has stabilized from the shock or rolling
disturbance.
Note: The anti-skip function provides for continues sound output when
the unit is subjected to shock or vibration. It will not compensate for errors
arising from the use of defective, scratched or dirty discs.
BBS function
Tap the BBS ON/OFF button to turn on the BBS to enhance the bass effect
of the music. Tap again to turn off the BBS.

Hold function

To prevent accidental function changes during active use, this unit is fitted
with a function hold. After the unit has been powered on and playing in CD,
slide the HOLD SWITCH to ON position. HOLD INDICATOR will show on the
LCD display.