Tools And Materials; Before You Begin - Kohler K-737 Guia De Instalacion

Tools and Materials

Adjustable Tubing Cutter
Wrench
1/4"
Hex Wrench
Thread
Sealant

Before You Begin

IMPORTANT! Risk of product damage. Do not apply direct heat to
the transfer valve body. Excessive heat will damage the plastic valve
components and plaster guard.
Observe all local plumbing and building codes.
Do not remove the plaster guard from the transfer valve until
instructed to do so.
A mixed water supply is required for this transfer valve.
If less than three accessories will be installed, do not plug any
outlets on this transfer valve without completing the two-way
conversion. The transfer valve is not intended to be used as a
shut-off valve.
Carefully plan the installation before beginning. Carefully read
the entire instructions. Component location, spacing, and
situational requirements can vary.
Shut off the main water supply.
Inspect the waste and supply tubing; replace if necessary.
1173682-2-A
Plus:
Solder
• 1/2" Piping or Copper
Tubing for outlets
• 3/4" Piping or Copper
Tubing for inlets
• 1/2" NPT Plug
Propane
Torch
2 Kohler Co.