Cooling Mode - Brandson Equipment 305040 Manual Del Usuario

6.4 Cooling mode

The appliance runs in normal mode
like a fan. If you also want to switch
on the air cooling, press the "AIR
COOLER" button on the remote
control or the control panel.
Once the air cooling is switched on,
the indicator light on the control
panel starts glowing.
Caution! The cooling effect of the air
cooler is only present in the immedi-
ate air stream of the appliance.
Make sure that there is water in
the water tank and that you do
not remove the water tank during
operation.
7. Filling the water tank
1. Switch off the appliance and
disconnect it from the mains.
2. Turn the water tank lock by
90° in the clockwise direction
and remove the water tank
carefully.
3. Turn the water pump lock by
90° in the clockwise direction
and remove the water pump
from its holder. Then remove
the water tank completely.
4. Fill the water tank with fresh
water upto the maximum
mark. To increase the cooling,
add ice cubes or ice packs to the water tank.
36
English