Playing Music From A Digital Audio Component (A-70 Only); Playing Music From A Computer (A-70 Only); Making An Audio Recording - Pioneer A-70-K Manual De Instrucciones

04 Operation
Playing music from a digital audio
component (A-70 only)
Outputs digital signals input to the DIGITAL IN
COAXIAL connectors.
1 Make a digital input connection.
• See Digital audio input connections (A-70 only) on
page 6.
2 Press COAXIAL to select DIGITAL IN
COAXIAL as the input source.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
• Sound is produced from the RECORDER OUT
terminals.
Note
• Digital signal formats that can be input to this unit
include linear PCM signals with sampling rates and
quantitative bits up to 192 kHz/32 bits (Depending
on the connected device and environment,
operation may not be successful).
12
En

Playing music from a computer (A-70 only)

Use this function to play digital audio input to the unit's
rear panel DIGITAL IN USB port.
1 Connect the unit to a computer via USB
cable
• See Using a USB cable to connect to a computer (A-
70 only) on page 7.
2 Press USB to select DIGITAL IN USB as
the input source.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
• Sound is produced from the RECORDER OUT
terminals.
3 Begin playback on the computer.
Note
• When using a USB cable to connect this unit to a
computer for playing music files, the following
linear PCM digital signals are supported:
– Quantitative bits: 16 bit, 24 bit, 32 bit
– Sampling rates: 44.1 kHz, 48 kHz, 88.2 kHz,
96 kHz, 176.4 kHz, 192 kHz
• Playback cannot be controlled from this unit during
use of this function; use your computer to control
playback.
• When disconnecting the USB cable, always stop
playback on the computer first.
• Sound may not be produced if your computer does
not support USB 2.0 HS.
• This unit does not support use of a USB hub.
Always use a USB cable to connect the unit directly
to the computer.
Important
• When using the DIGITAL IN USB port to input
audio files from a computer to this unit, it may be
necessary to install a special driver on the
computer. For details, see the website of Pioneer.

Making an audio recording

You can make an audio recording from any audio source connected to the amplifier.
SACD/CD player
Network audio player
/I STANDBY/ON
STANDBY PURE AUDIO Hi-Bit 32
iPod/USB
5V 2.1A
Audio recording component
(CD recorder, tape deck, etc.)
1 Select the source you want to record.
iPod dock, etc
Turntable
iPod
Music>
Extras>
Settings>
Shuffle Songs
Backlight
Tuner
MENU
N-50
NETWORK AUDIO PLAYER  
FUNCTION  
  
Playback
1
Recording
2 Start recording, then start playback of
the source component.
Caution
• Confirm that the short pin plugs are not inserted in
the RECORDER OUT terminals, since malfunction
will result if they are inserted.