Candy CID 30/G3 Manual De Instrucciones página 23

• If the cable is damaged or to be replaced, the operation must be carried
out the by after-sale agent with dedicated tools to avoid any accidents.
• If the appliance is being connected directly to the mains an omnipolar
circuit-breaker must be installed with a minimum opening of 3mm between
contacts.
• The installer must ensure that the correct electrical connection has been
made and that it is compliant with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and replaced by authorised
technicians only.
• The yellow/green wire of the power supply cable must be connected to
the earth of both power supply and appliance terminals.
• The manufacturer cannot be held responsible for any accidents resulting
from the use of an appliance which is not connected to earth, or with faulty
earth connection continuity.
• If the appliance has a socket outlet, it must be installed so that the
socket outlet is accessible.
Selection of cooking vessels
Iron oil frying
Stainless steel
Iron plate
You may have a number of different cooking vessels
1. This induction hob can identify a variety of cooking vessels, which you can test by
one of the following methods:
Place the vessel on the cooking zone. If the corresponding cooking zone displays a
power level, then the vessel is suitable. If "U" flashes, then the vessel is not
suitable for use with the induction hob.
2. Hold a magnet to the vessel. If the magnet is attracted to the vessel is suitable for
use with the induction hob.
NB: The base of the vessel must contain magnetic material.
It must have flat bottom with a diameter according to the table 1 below.
Iron pan
Iron kettle
EN-23
Enamel
Enamel cooking
stainless steel
kettle
utesil