Charging The Shaver; Indicator Lights - Braun Flex XP II 5770 Manual Del Usuario

Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Model 5775 only: Low charge light (red)
8 Special cord set

Charging the shaver

• When charging for the first time: Using the
special cord set, connect the shaver with an
electrical outlet. The shaver must be
switched off. Charge it for at least 4 hours
(special cord set and shaver might get
warm). Once the shaver is completely
charged, shave until fully discharged. Then
recharge to full capacity again (1 hour).
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum bat-
tery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 60 °F to 95 °F/15 °C to 35 °C.
• When fully discharged, you may also shave
with the shaver connected to an electrical
outlet via the special cord set.

Indicator lights

The green charging light shows that the shaver
is being charged. When the rechargeable bat-
tery is fully charged, the green charging light
intermittently blinks on and off. This indicates
that the battery maintains its full capacity.
Model 5775 only:
The red low-charge light glows when the battery
capacity has dropped below 20% provided the
shaver is switched on. The remaining capacity
will then be sufficient for 2 to 3 shaves.
6
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Tips for the perfect shave
• It can take up to 14-21 days for your beard
to adjust to the new shaving system.
• Shave before washing your face or taking
a shower, as skin tends to swell after
washing.
• The dryer the skin, the closer the shaving
results will be.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance
replace your foil and cutterblock every
18 month or when worn.
Cleaning
The hand-held unit shall be detached from the
power supply cord before cleaning. The
shaver shall not be used until it has dried.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under hot running water is an easy
and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
Next, switch the shaver off and press the
release buttons. Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.