CARE FITNESS CV-525 Manual Del Usuario página 29

1. Use UP/DOWN keys to select the BODY FAT (P24) program.
2. Press the ENTER key to enter your workout program.
3. The HEIGHT will flash and you can press UP or DOWN keys to set your HEIGHT. Press ENTER key
to confirm your HEIGHT. The default HEIGHT is 170cm or 5'07" (5feet 7 inches).
4. The WEIGHT will flash and you can press UP or DOWN keys to set your WEIGHT. Press ENTER key
to confirm your WEIGHT. The default WEIGHT is 70kgs or 155lbs.
5. The GENDER will flash and you can press UP or DOWN keys to select your sex. Number 1 means
man and number 0 means female. Press ENTER key to confirm your Gender. The default sex is 1
(MAN).
6. The AGE will flash and you can press UP or DOWN keys to set your AGE. Press ENTER key to
confirm your AGE. The default AGE is 35.
7. Press the START/STOP key to begin body fat measurement. If the window show E on the window,
please make sure your hands are attached well on the grips or the chest belt is touch well on your
body. Then press the START/STOP key again to begin body fat measurement.
8. After finished your measurement, the computer will show the values of BMR, BMI and FAT PERCENT
on the LCD display. Furthermore, the computer will show your own exercise profile for your body type.
9. Pedaling the machine to begin exercise
Operation guide:
1. Sleep Mode: The computer will enter the sleep mode when there is no signal input and no keys be
pressed after 4 minutes. You can press any key to wake up the computer.
Error Message:
E1 (ERROR 1):
Normal state: During workout, when the monitor did not get the count signal from the gear motor more
than 4 seconds and check under successive 3 times then the LCD will show E1.
Power on state: The gear motor will return to zero automatically, when the signal of motor cannot be
detected for more than 4 seconds then the gear motor's driver will be cut off immediately
and show the E1 on the LCD display. All the other digital and function mark are blank, and
the output signals are cut off also.
E2 (ERROR 2): When the monitor read the memory data, if the I.D. code is not correct or the memory IC
damages then the monitor will show E2 immediately at power on.
E3 (ERROR 3): After 4 seconds by start mode, the computer detects the faulty motor did not leave the zero
point then the LCD bar displays "E3".
LCD Workout Graphics
PRESET PROGRAM PROFILES:
PROGRAM 1
MANUAL
PROGRAM 4
ROLLING
PROGRAM 7
RAMP
PROGRAM 2
STEPS
PROGRAM 5
VALLEY
PROGRAM 8
MOUNTAIN
29
PROGRAM 3
HILL
PROGRAM 6
FAT BURN
PROGRAM 9
INTERVALS