T
:
HIS KIT CONTAINS
• 1 W
ALL EXTENSION
• 1 P
(
ARTS BAG
SERVICE PART NO
1
, 8
. 8
5/8"
WIRE CLAMP
NO
X
8
. 10-32
3/8"
AND
NO
X
SCREWS
F
OLLOW HOOD INSTALLATION GUIDE STEPS
PRIOR TO INSTALL WALL EXTENSION
Insert house wiring through wall extension top, right hole.
Rest the back cavity of the wall extension on wood mounting
strip (provided with the hood). Secure upper portion of the wall
extension to wood mounting strip with (up to) 6 no. 8 x 5/8"
screws (included).
Drill two 3/16" diameter holes into the wall for wall anchors
through two of the existing lower holes of the wall extension.
Then, install both wall anchors, both washers and 2 no. 8 x 5/8"
screws (included).
4
TO
HD0475
2 W
ALL ANCHORS
Using pliers, unfold to 90° both wall extension metal tabs to
align hood during installation.
90°
T
AB
HR0071
. S9701887)
:
INCLUDING
, 2
SCREWS
WALL ANCHORS
1
TO
6 S
CREWS
/
/
WASHERS
SCREWS
W
ALL
I
NSTALLATION
• Although not recommended, if blowers need to be removed,
reinstall them using 10-32 locknuts included in hood parts
, 2
WASHERS
bag (maximum torque of 20 lb.).
• Hold the hood until it is completely secured to the wall
extension.
6
Remove the hood wiring cover and insert house wiring through
the hood wire clamp.
HD0469
Rest the back cavity of the
hood on wall extension
metal tabs. Secure hood
to wall extension using
8 provided no. 10-32 x 1/2"
quadrex screws (4 on both
sides). See
at right.
Attach 10" round duct
to adapter. Tighten wire
clamp.
F
E
AWEPD S
XTENSION
I
NSTRUCTIONS
CAUTION
W
IRING COVER
illustration
S
LOCATIONS
HD1020
OLLOW HOOD INSTALLATION GUIDE STEPS
TO FINALIZE HOOD INSTALLATION
ERIES
CREW
9
11
TO