Operating Instructions-Remote Control - Fanimation FP1280 Serie Manual De Instrucciones

IMPORTANT:
1.
Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3. Remove battery cover with a small screwdriver or ball
point pen firmly press the tab and slide battery cover off.
(Figure 3)
4. Operating & Using Hand-held Remote (Figure 4):
Install two piece of 3 volt battery (If not using for long
periods of time, remove battery to prevent damage to
store hand-held remote). the hand-held remote away from
excess heat or humidity.
•
• REV Push Button – toggles airflow direction
• Light Push Button – on/off, hold for infinite light level
Chemical Burn Hazard. Keep batteries away from
children.
5. Replace battery cover on remote control. Be sure the
hole of battery cover firmly into the tab. (Figure 5)

Operating Instructions-Remote Control

WARNING
For illustrative purposes only-not
intended to cover all types of controls
3V, CR2032
BATTERY
(2 PCS)
12
Figure 1
MAIN FUSE BOX
Figure 2
REMOTE
CONTROL
Figure 3
Figure 4
Figure 5