Motor Assembly- Unpacking Instructions And Parts Identification - Fanimation FP1280 Serie Manual De Instrucciones

This manual is designed to make it as easy as possible for you to assemble,
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 8). If you feel you
do not have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
Motor Assembly - Unpacking Instructions and Parts Identification
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or missing.
This product is designed to use only those parts supplied
with this product and/or any accessories designated
specifically for use with this product by Fanimation.
Substitution of parts or accessories not designated for
use with this product by Fanimation could result in
personal injury or property damage. Contact your retail
store for missing or damaged parts.
FP1280 Motor Assembly and Hardware Parts Identification
FP1280
Motor Assembly with
Switch Cap Receiver (1)
Hardware Bags
Wire Nuts (3) Lag Bolt,
1/4" x 2" (4)
Flat Washers,
Ø5 x Ø14 x 1mm (4)
install, operate and maintain your ceiling fan
• One stepladder
• One wire stripper
Punch Tool (1)
Belt Clamps (2)
Rivet Tool (1)
"J" Lag Bolt,
1/4" x 2" (1)
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
nstalled
p to
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing, contact your local retailer.
Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 15)
• Fan Motor Assembly with built-in control receiver
and hardware parts (Figure 1)
• Pulley Head Assembly and hardware parts (Figure 2)
Rivets, 3/32" x 7/32" (8)
& Rivet Washers,
0.1 x 0.23 x 0.35 mm (8)
Figure 1
4
Materials
ire ength ire i e
ft
ft
Hand-held Remote (1)
Control bracket (1)
Plastic plug (4)
#3-1" self tap screws (2)
#6-32 x 3/4" screws (2)
#6-32 x 1" screws (2)
Plastic anchor (2)
Batteries (2)
NOTE: The illustration shown is not to
scale or its actual configuration may vary.
Parts and packings subject to change
without notice.