Operating Instructions-Tr34 Remote Control - Fanimation The Keistone FPD8088-NL Serie Manual Del Propietário

Operating Instructions - TR34 Remote Control
1. Restore electrical power to the outlet box by turning the
electricity on at the main fuse box. (Figure 1)
2. To make fan operational, install 12-volt battery (included
in remote control package) into the remote. (Figure 2)
3. Follow the below steps to set the remote: (Figure 3)
a) With the fan's power off, arrange code switches to
desired code setting.
b) After installing the unit and restoring power to the fan,
press and hold the "SET" button 1 - 5 seconds. You
must press the "SET" button within 60 seconds of
restoring power to the fan.
c) The fan will start to run and begin the control setting
process. The fan will run in both directions for a total
of approximately 5 minutes.
d) When the fan stops after approximately 5 minutes, the
control and speed setting process is complete and the
fan is ready for use.
CAUTION
If you are not expecting to use the remote for a long
period of time, remove the battery to prevent damage
to the remote. Be sure to store the remote away from
excess heat or humidity.
4. Remote functions: (Figure 4)
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
Button:
Turns the fan off.
Reverse button:
Controls fan direction.
II = low speed
IV = medium speed
VI = high speed
12
ON ON
ON ON
ON ON
ON ON
Figure 1
Figure 2
Figure 3
Figure 4