Leggett & Platt PREMIER FOUNDATION DESIGN Manual Del Usuario página 25

REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
STEP 6
Using a pointed object, press and hold the learn
button for two seconds (FIGURE 26). The underbed
light will "chirp" once to indicate base is in pairing
mode.
FIGURE 26
LEARN
BUTTON
CONTROL
BOX
STEP 7
Next, within 15 seconds, simultaneously press
the Set 1 and Set II buttons on remote control 1
(FIGURE 27). The underbed light will "chirp" twice
to indicate remote control is paired.
Then, simultaneously press the Set 1 and Set II
buttons on remote control 2 (FIGURE 27). The
underbed light will "chirp" twice to indicate remote
control is paired.
One or two remote control(s) are now programmed to
operate two bases.
NOTE
TO UNPAIR THE REMOTE(S), USING A POINTED
OBJECT, PRESS AND HOLD THE LEARN BUTTON
ON THE CONTROL BOX FOR 10 SECONDS.
THE UNDERBED LIGHT WILL "CHIRP" 4 TIMES
WHEN PROCESS IS COMPLETE.
SET I
BUTTON
FIGURE 27
Premier Series
™
SET II
BUTTON
Owners Manual 99301588-b
25