Cleaning And Maintenance - Remington EP7 7-IN-1 Manual Del Usuario

ENGLISH
• Do not use the epilating head on irritated skin or skin with varicose veins, rashes, spots,
moles or wounds without consulting a doctor. People with reduced immune response
e.g. during pregnancy, or people who suffer from diabetes mellitus, haemophilia or
immunodeficiency should also consult their doctor before using this product.
• Do not use the Exfoliating Brush or Pedicure Head on broken, sore or irritated skin or
on warts or any other protrusions.
• For hygiene reasons do not let another person use your epilator. It is recommended for
use by one person only.

CLEANING AND MAINTENANCE

To ensure long lasting performance of your epilator, clean the head assembly regularly.
CLEANING THE EPILATION HEAD AFTER EACH USE:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and open the head assembly (Figure F).
• Turn the head assembly upside down.
• The epilator head can be removed and rinsed for cleaning. For optimal cleaning; brush
hairs from the tweezers before rinsing (Figure G).
• Although the epilator is suitable for use under running water, it is not recommended to
submerge the unit under water.
NOTE: Do not completely submerge in water. The epilator head can be submerged after it
has been removed from the epilator body.
TO REMOVE RESIDUE:
• To remove residue from the stainless steel tweezers, dampen a swab with alcohol.
• Gently run the swab over the tweezers until the residue has been removed.
• CAUTION: Make sure that the cotton swab is not soaked in alcohol as this may damage
the epilator.
CLEANING THE SHAVER HEAD AFTER EACH USE:
1. Ensure the epilator is turned off and disconnected from the mains.
2. Press the head release button and remove the shaving head.
3. Remove the blade and trimmer assembly by placing your fingers either side of the
assembly and pulling upwards.
4. Gently shake the blade and trimmer assembly to remove the hair. Use the cleaning
brush to brush the trimmers and shaver housing.
5. Replace the blade and trimmer assembly.
NOTE: Never use the cleaning brush on the foil as damage may occur.
CLEANING THE PEDICURE HEAD AFTER EACH USE:
1. Ensure the epilator is turned off and disconnected from the mains.
2. Press the head release button and remove the pedicure head.
8