Uline H-2932 Manual De Instrucciones página 2

TO PROGRAM TO A 6-DIGIT MASTER CODE:
NOTE: The factory code is 135243. It must be
overwritten by a new 6-digit master code.
1. With knob in the unlocked position, press the
program button 5 times until the green LED lights up.
2. Enter the default 6-digit factory code.
a. If the code is correctly entered, the green and
red LEDs will simultaneously flash.
b. If the code is incorrectly entered, the red LED will
flash.
3. Enter the factory code again. The red, green and
yellow LEDs will simultaneously light up.
4. Enter the desired 6-digit master code. The red,
green and yellow LEDs will simultaneously flash.
5. Enter the newly created master code again.
a. If incorrect, the red LED will flash.
b. If the code is entered correctly, the red, green
and yellow LEDs will flash consecutively for 5
seconds.
The master code is now stored. The factory code is
erased. To program a new master code, follow the
same procedure above, entering the current master
code instead of the factory code.
TO PROGRAM A SUPERVISOR CODE:
NOTE: Default supervisor code is 123. It must be
overwritten by a new 3-6 digit supervisor code.
1. With the knob in either the unlocked or locked
position, press the program button.
2. Enter the master code.
a. If you do not enter a master code within
10 seconds, the red LED will flash and exit
programming.
b. If you enter the master code incorrectly, the red
LED will flash and exit programming.
c. If you enter the master code correctly, the red LED
will light up for 10 seconds.
3. Enter a supervisor code 3-6 digits in length.
4. Push the program button again to finish. Storing a
code successfully is indicated by the green LED
flashing 6 times.
PAGE 2 OF 12
PROGRAMMING
TO PROGRAM A USER CODE:
1. With the knob in the unlocked or locked position,
press program button twice. The red LED will light up.
2. Enter the supervisor code.
a. If you do not enter the supervisor code within
10 seconds, the red LED will flash and exit
programming.
b. If you enter the supervisor code incorrectly, the
red LED will flash and exit programming.
c. If you enter the supervisor code correctly, the
yellow LED will light up for 10 seconds.
3. Enter a user code 3-6 digits in length. If you do not
enter a user code within 10 seconds, the red LED will
flash and exit programming.
4. Push the program button again to finish. Storing a
code successfully is indicated by the green LED
flashing 6 times.
TO ERASE THE USER CODE:
1. Press the program button twice. The red LED will
light up.
2. Enter the supervisor code.
a. The yellow LED will light up for 10 seconds.
b. If the supervisor code is entered incorrectly, the
red LED will flash twice and exit programming.
3. Enter 1-1-1-1-1.
4. Press the program button. If the user code is
successfully erased, the green LED will flash 6 times.
0521 IH-2932