universalblue UVT131-21 Manual De Instrucciones página 30

STEP BY STEP
Note: The images are for guidance only and should be used to
support the installation.
1. Open the box and remove the fan (fig. 1).
2. Mount the support plate on the ceiling with the appropriate
screws. Make sure it is securely fastened. Caution: The screws
supplied are for wooden beams and concrete ceilings. (fig. 2).
3. Remove the unthreaded screw from the extension rod and save
it. Also remove the upper screws in the hemisphere of the
extension rod and reserve them.
4. Pass through the support rod, the canopy and the lower cover.
Then run the cables through the inside of the rod. Fit the rod into
the motor body and replace the previously removed threadless
screw and tighten the motor body screws (fig. 3).
5. Slide the lower canopy to the engine body and screw.
6. Secure the support rod to the engine using the engine pin and
nut.
30