universalblue UVT131-21 Manual De Instrucciones página 31

7. Place the hemisphere of the support rod, tighten it with the
screw and connect the electric cable coming from the roof to the
screw terminal located at the top of the support rod, tighten the
screws.
8. Then hang the fan to the ceiling and make the appropriate cable
connections. Make sure that the receiver is inserted into the top
of the support plate (see Connecting the remote control).
9. Slide the upper canopy up and align the holes to the screws,
turning the top panel until it locks into place. Then tighten the
screws. (fig. 4)
10. Align the screw holes on the blades with the holes on the fan
head; then screw in the fixing screws until the blade is fully
attached. (fig. 5)
11. Repeat the process until the 5 blades are assembled (fig. 6)
12. Remove the screws from connect plate of the motor, please
organize all the wires carefully into connect plate To mount the
light, assemble and align the holes in the back of the LED light
with the three screws on the motor connection plate. (fig. 7)
13. Then tighten the three screws on the LED board and connect the
cable along with the motor cable. Please make sure that the
lighting kit is securely fastened after tightening the screws. (fig.
8)
14. Place the lampshade on the fan and turn it clockwise until it is
fixed (fig. 9).
Note: you can also mount the blades in the fan body before making
the electrical connections.
31