Craftsman BOLT ON 34980 Manual Del Operador página 6

OPeRATION
• To switch the tool on, press the variable speed switch on the power
unit. The tool speed depends on how far you press the switch.
• To switch the tool off, release the variable speed switch.
NOTe: This attachment only operates in the forward direction, the
forward/reverse slider of
switched to reverse.
INSTAllING/ReMOVING AcceSSORIeS
This tool features a tool-free accessory changing system. This allows for
faster accessory changes without the need for wrenches or hex keys like
other oscillating tool systems.
• Grasp the tool and squeeze the accessory clamping lever as shown in
figure A.
• Clean any residual debris from the tool shaft and the accessory holder.
• Slide the accessory into the accessory holder making sure the
accessory engages all eight pins on the holder and is flush with the
surface of the holder.
• Release the accessory clamp lever.
• Some accessories, such as scrapers and blades can be mounted at an
angle if required as shown in figure B.
PlUNGe cUTTING - fIGURe c
WARNING:
Hold saw firmly with both hands for all cutting operations.
WARNING:
Inspect work area for hidden electrical wiring, gas pipes
or water pipes before making blind or plunge cuts. Failure to do so may
result in electrical shock, fire, explosion, or property damage.
WARNING:
ALWAYS use safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT.
WARNING:
CUT HAZARD. Before cutting any type of material, be
sure it is firmly anchored or clamped to prevent slipping.
WARNING:
CUT HAZARD. Let the tool work at its own pace. Do not overload, blade breakage
may occur.
WARNING:
CUT HAZARD. This tool has no provision to lock the switch in the ON position, and
should never be locked in the ON position by any other means.
To make a cut:
• Clearly mark the desired cutting area.
• To switch the tool on, pull the variable speed trigger on the power unit. The tool speed depends on
how far you pull the trigger.
• Switch the tool on before applying pressure and slowly feed the plunge cut blade into the workpiece
at the marked location.
WARNING:
CUT HAZARD. Ensure the blade is not in contact with cutting surface before
starting saw.
• Advance the blade along the cutting line until cut is completed. Don't force the tool; let the blade cut
at its own speed.
• To switch the tool off, release the trigger.
NOTe: Always use the appropriate type of saw blade for the work piece material and type of cut. Cut
only with sharp blades; they cut cleaner, faster and put less strain on the motor while cutting.
the Power Unit should not be able to be
6
A
B
c