Craftsman BOLT ON 34980 Manual Del Operador página 7

SANDING
WARNING:
fire hazard. When working on metal surfaces, do not use a vacuum cleaner
because sparks are generated. Wear safety glasses and a dustmask. Due to the danger of fire, do not
use your sander to sand magnesium surfaces. Do not use for wet sanding.
• To switch the tool on, pull the variable speed trigger on the power unit. The tool speed depends on
how far you pull the trigger.
• To switch the tool off, release the trigger.
NOTe: Do not rest fingers on platen during use. Move it in long sweeping strokes across the
surface, letting it do the work. Light pressure is all that is required for sanding. Excessive pressure
will slow the tool and produce inferior results. Check your work often, product is capable of removing
material rapidly. Excessive force will reduce the working efficiency and cause motor overload.
Replacing the sanding sheet regularly will maintain optimum working efficiency.
NOTe: Always ensure the workpiece is firmly held or clamped to prevent movement. Any movement
of the material may affect the quality of the sanding finish.
INSTAllING/ReMOVING SANDING SHeeTS - fIGURe D
A diamond shaped platen uses a hook and loop adhesion system to
attach the sanding sheets. The platen allows you to use it on large flat
surfaces and tight spots or corners.
• Attach the sanding platen as described under "Installing/Removing
Accessories."
• Align the edges on the sanding sheet, with the edge of the sanding
platen and press the sanding sheet onto the platen.
• Firmly press the base with the sanding sheet attached against a flat
surface and briefly switch the tool on. This provides for good adhesion
between the platen and the sanding sheet, and also helps to prevent
premature wear.
• When the tip of the sanding sheet becomes worn, detach the sheet from the platen, rotate and reapply.
ADAPTeR (cATAlOG # BDcMTOA)
An accessory adapter kit is provided with BDCMTOA. The adapter is
compatible with many manufacturers' accessories, but if unsure, confirm
with the specific manufacturer that their accessory is compatible.
cAUTION:
To avoid injury, do not use any accessory for an
application where the adaptor may fail to hold the accessory.
cAUTION:
Read and follow all manufacturers' safety warnings for
any accessories used with this tool.
cAUTION:
To avoid injury, ensure adapter and accessory are
securely tightened.
cAUTION:
Do not use this adaptor with Black and Decker
accessories. Attach Black and Decker accessories with the accessory
clamping lever (2) according to the instructions in this instruction manual.
• To attach, place adapter plate (7) onto the oscillating tool attachment
with protrusions facing up as shown in figure e.
• Place accessory and the adapter bolt and washer (8) on top of adapter
and tighten with the hex wrench as shown in figure f.
• To remove, loosen the bolt and washer with the hex wrench and
remove the accessory and adapter.
7
D
e
7
Protrusion
f
8