Helpful Hints; Troubleshooting - Craftsman BOLT ON 34980 Manual Del Operador

HelPfUl HINTS

• Always ensure the workpiece is firmly held or clamped to prevent movement. Any movement of the
workpiece may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine grit for the
finishing surfaces. If necessary, first make a test run on scrap material.
• Excessive force will reduce the working efficiency and cause motor overload. Replacing the sanding
sheet regularly will maintain optimum working efficiency.
• Do not allow the sandpaper to wear away, it will damage the sanding platen.
MAINTeNANce
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
iMpOrtant: To assure product SAFETY and RELIABILITY, repairs, maintenance, and adjustment
(other than those listed in this manual) should be performed by
qualified service personnel
AcceSSORIeS
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous.
Additional attachments and accessories for use with this tool are available at extra cost from your local
Sears store or Sears service center.
If you need assistance regarding accessories, please call:
Problem
• Attachment will not start.
NOTe: Refer to Power Unit instruction manual for troubleshooting solutions regarding operation of the
Power Unit.
.

TROUBleSHOOTING

Possible cause
• Attachment is not secured.
a qualified service dealer or other
1-877-795-2353
Possible Solution
• Make certain the attachment is fully pushed into
the Power Unit.
8
.