Publicidad
• Place a large washer (38), short spacer tube (41), and
the drive disk (8) onto the shaft. Fit the short spacer tube
and large washer onto the flanged bearing in the end
plate. See figure 15.
8
fIGURE 15
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 16.
20
7
fIGURE 16
41 38
10
• Place a 5/8" flat washer (33), the compression spring
(49) and another 5/8" flat washer onto the shaft. See
figure 17.
33
fIGURE 17
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 18.
20
fIGURE 18
• Place a long spacer tube (20) onto the shaft. See
figure 19.
20
fIGURE 19
49
7
Publicidad
