Publicidad
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 20.
20
fIGURE 20
• Place a long spacer tube (20) onto the shaft.
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 21.
20
7
fIGURE 21
• Place a short spacer tube (41) and then a large
washer (38) onto the shaft. Fit the short spacer tube and
washer onto the end of the flanged bearing in the end
plate. Push the shaft on through the flanged bearing in the
end plate. See figure 22.
41
38
fIGURE 22
7
• Place a 5/8" flat washer (33) onto the end of the spike
disk shaft and secure the shaft with a 1/8" x 1-1/2" cot-
ter pin (23) by spreading the ends of the cotter pin. See
figure 23.
• Fasten the drive disk to the shaft using a 1/8" x 1-1/2"
cotter pin (23) by spreading the ends of the cotter pin. See
figure 23.
33
fIGURE 23
• Remove connecting link from chain and assemble the
chain (47) onto the two sprockets on the left side of the
hopper. Fasten the ends of the chain together using the
connecting link. See figure 24.
• Place the chain cover over the chain and fasten it to
the hopper end plate using two self tapping screws (31).
See figure 24.
47
CONNECTING
LINK
fIGURE 24
11
23
23
8
31
Publicidad
