Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pre-installation Information
4
• Check to make sure that the inside
diameter of the air-tight cover for your
lamp is at least 60 mm. If it is too small,
there is the risk of unsuccessful installa-
tion of the heat sink and the control box.
Min60mm
26mm
Figure-1
• The LED-HL [≈H1] lamp is not for use
with all types of cars. Please consult a
professional sales representative.
• Please have a technician at a profes-
sional service location install the LED-
HL [≈H1] lamp.
5
• Swing to open the air-tight cover for
the original headlight.
• Loosen the spring latch and remove the
halogen lamp from the existing head-
50mm
light assembly.
• Insert the plastic ties into the pre-
secured holes on the control box.
• Insert the ties into the wiring harness
for the lamp.
Installation Steps
Figure-2
5
Publicidad
Tabla de contenido
