Philips X-tremeUltinon LED-HL[≈H1] Manual Del Usuario página 6

• Fasten the ties.
• Connect to power (there is only 1 pin to
connect normally, but if the positive and
negative wire is separated please pull
out the A pin to connect negative wire)
A
• Insert the control box into the internal
empty chamber of the lamp.
• Unscrew the LED-HL [≈H1] heat sink
from the lamp.
6
• Adjust the installation angle of
the central plate.
(1). If the angle of the halogen lamp
(2). Use the Allen key to loosen the three
A
(3). Turn the central plate and make sure
is vertical in the optic, there is no
requirement to adjust the angle of the
LED central plate. Otherwise, it is
required to adjust the installation
angle of the central plate for the
LED-HL [≈H1] lamp.
set screws of the central plate as is
shown below.
that the assembly is aligned vertically
(see the hollow arrows in the follow-
ing figure) and that the LED shines
toward the right and the left sides of
the reflector. Then, fasten the screws
for the central plate.
Illumination
orientation
of the left
LED
Illumination
orientation
of the right
LED