Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Install the LED-HL [≈H1] lamp into the
headlight and buckle the spring latch.
Attention: do not let the spring latch
touch the wires.
• Install the heat sink onto the lamp.
• Connect the control box to the two con-
nectors on the lamp.
• Place the wiring harness into the
chamber of the lamp. Be careful to
avoid the air inlet of the fan.
• Put on the air-tight cover for the lamp.
• Check if the lamp works normally and
if the light pattern is okay. If the light
pattern is too low or too high, adjust
the horizontal adjustment knob for the
lamp until the position is correct.
• Place the removed halogen lamp into
the white empty box.
7
Publicidad
Tabla de contenido
