Before Cooking; During Cooking; Finishing Cooking - T-Fal NutriCook Guía De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using NutriCook

Before cooking

• Every time you use your Nutricook, first check that the
control panel is correctly fitted and tightened (using a
coin) and check that the operating valve (L) located
inside the lid can move, by moving the programme
selector (F) to
finger. Fig. 17.
• Also check that the safety valve (M) can move:
see Fig. 18 and refer to the "Cleaning and
Maintenance" heading.
• Close the NutriCook.
• Move the selector to one of the programmes as shown
in your recipe book. Fig. 9.
• Programme the Smart Timer
shown for your recipe. Fig. 10.
• Place the NutriCook on a heat source set to maximum
power.
Just like any other
cooking appliance,
always pay close
attention to it,
especially when
using NutriCook
near children.
The steam jet
coming from the
steam release
outlet (A) is very
hot.

Finishing cooking

• When the soft cooking phase is finished, the Smart
®
Timer
's signal sounds indicating that cooking is
finished.
.
• Check that the pressure indicator (D) has dropped back
down.
• Raise the Open/Close handle to the vertical position to
open the lid. Fig.1.
and pressing the valve with your
®
for the cooking time
• When the signal sounds, the Smart Timer
you need to turn the heat down so there is a constant,
steady release of steam.
NutriCook steam cooking with pressure starts and the
Smart Timer
• Once the NutriCook's steam cooking with pressure phase
is finished, the signal sounds and the Smart Timer
indicates that you need to turn off the heat and move the
cooking programme selector to
• A jet of hot steam, and possibly droplets of water, escapes
from the steam outlet (A) in a vertical direction.
The soft cooking phase starts (this time is ready
programmed).
• If you accidentally open your NutriCook during the soft
cooking phase, close it back up immediately, this will have
no effect on cooking.
• Never remove the Smart Timer
cooking or soft cooking phases.
®
counts down.
decompression valve
Always position the
NutriCook so that the
programme selector (F)
faces you.

During cooking

®
indicates that
. Fig. 8.
®
during the pressure
To move NutriCook, use
the carrying handles on
the side of the cooker.
EN
FR
ES
®
14

Publicidad

Tabla de contenido
loading

Tabla de contenido