4
1
4
5
3
2
6
5
3
4
3
A
4
5
3
2
6
5
3
4
Scope of delivery:
1x touring windshield (1)
2x cap nuts M5 (2)
4x fasson washers (3)
4x bushes for frame protector (4)
4x flat-head screws M5x16 (5)
2x hexagon nuts M5 (6)
Preparations
- Remove the headlight mask as described in the owner's manual.
- Disconnect the turn signal and headlight connectors as described in the
owner's manual.
- Remove the headlight from the headlight mask.Assembly
Assembly
- Cut out the template provided in the appendix to these instructions.
NOTE:
Remeasure the dimension on the template (10 cm between the upper holes)
as copying or incorrect scaling of the printer may result in deviations.
If the template does not show the correct dimension:
contact the dealer -> download the pdf and print out without scaling!
- Position the template on the original headlight mask and mark the drill
hole positions.
- Pre-drill them with a small drill and then drill them to a diameter of 9 mm.
- Insert the bushes (3) on the rear of the windshield.
NOTE:
Ensure that the bushes (3) are positioned correctly (see insert (A))!
- Insert the fasson washers (4) on the front of the windshield.
- Mount the windshield on the headlight mask with the four hex screws (5).
NOTE:
Attach the two top screws with the cap nuts (2) and the two bottom screws
with the self-locking nuts (6).
Final assembly
- Mount the headlight in the headlight mask using the original screws.
- Connect the headlight and turn signal connectors as described in the
owner's manual.
- Mount the headlight mask as described in the owner's manual.
60008046000
54803092060
0985050003