Campbell Hausfeld CL153400 Instrucciones De Operación página 5

Maintain a fi rm grip on
quick connect and press
back to insert or remove
hammer bit
Figure 3 - Quick Connect Retainer Operation
QUICK CONNECT RETAINER
The quick connect
retainer or spring
retainer must be used to hold the
hammer in place. Personal injury can
occur if the hammer is not secure.
The quick connect retainer holds the
hammer in place. The retainer must be
securely attached and the three set
screws must be tightened completely
using a hex wrench (See Figure 3). The
retainer pulls back for easy hammer
insertion and snaps forward to hold the
hammer. The retainer is a normal wear
item and should be replaced when worn.
REGULATOR
Some air hammers are equipped with a
built-in air regulator to reduce the blow
rate. It is located next to the air inlet. Turn
the knob counter-clockwise for the fully
open, highest speed. Gradually turn the
knob clockwise to reduce the speed (See
Figure 4).
Quick Connect Retainer
Air Inlet
Figure 4
www.campbellhausfeld.com
CL153400
Regulator
5