Set-Up Instructions - Campbell Hausfeld CL153400 Instrucciones De Operación

12. Keep ALL nuts, bolts and screws
tight and ensure equipment is in safe
working condition.
13. ALWAYS secure workpiece in a vise
or clamp.
14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
15. ALWAYS work in a well ventilated
area and wear OSHA approved dust
mask.
The spring retainer
must be used to
hold the chisel in place. Personal injury
can occur if the chisel is not secure.
16. Risk of electrical shock:
this tool is conductive.
Do not hammer into walls
containing live electrical
wiring.
Figure 1
Operation

SET-UP INSTRUCTIONS

Air tools require a supply of clean, dry air
at 90 PSI (6.2 bar). An air supply system
with filter, regulator, and lubricator (FRL)
as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104
(3/8 inch) or PA2114 (1/2 inch) is
recommended.
Water in the air supply can damage the
tool. Drain condensate from compressor
tank and filter daily.
All hoses and fittings must be the correct
size and tightly fastened. Refer to Chart 1
for minimum sizes.
Tool Air Consumption
Less than 9 SCFM @ 100% usage
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100% usage
Chart 1 - Suggested minimum hose diameter to
use based on 50 ft length hose and continuous
SCFM rating of tool. The use of fittings and longer
hose may require a larger diameter hose to be
used.
Option 1: Individual components
Filter Regulator Lubricator
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
www.campbellhausfeld.com
CL153400
Hose ID
1/4 inch
3/8 inch
1/2 inch
3