Technical Service; Replacement Parts Information - Campbell Hausfeld CL153400 Instrucciones De Operación

Operating Instructions
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any
maintenance on the air system. Personal
injury and/or property damage could
occur.
STORAGE
The chisel/hammer must be lubricated
before storing. Follow the air piston
lubrication instructions with an exception
to step 3. Only run the chisel/hammer
for 2 to 3 seconds instead of 7 to 10
seconds because more oil needs to
remain in the chisel/hammer when
storing.

TECHNICAL SERVICE

For information regarding the operation
or repair of this product, please call
1-855-504-5678.
6
REPLACEMENT PARTS
INFORMATION
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
NOTE: Hammers are not included with
some tools. Any hammer with a .401
Parker taper shank size can be used.
Campbell Hausfeld offers five commonly
used hammers (Part number PA1003 or
MP2875*).
* PA1003 is a five piece set of hammers each
six inches in length. MP2875 is a 4 piece
set of hammers each three inches in length
(does not include the sheet metal cutter).
Figure 5 - Hammer Bits
www.campbellhausfeld.com
Weld Buster
Splitter
Punch
Flat
Sheet Metal
Cutter