EN
Day/week timer
Press the „W/24H" key to switch between the settings for the day timer and the week
timer. The display shows „DayTimer" and „Weektimer" accordingly.
Day timer: With this setting, the display shows „DayTimer". To set the hours, press
„Weektimer" on the remote control. Select an hour with the arrow keys (13,14). Use the
arrow keys (16) to change to the minutes setting. Set the minutes with the arrow keys.
Confirm with the OK key and save the settings made.
Weekly timer: The weekly timer allows four operating cycles per day and seven days
in a week. Weektimer" appears in the display. Press Settings (16) on the remote control
to call up a day (display (6) flashes). Use the arrow keys (13,14) to select the first
operating cycle. Press Settings (16) to go to the selection of a start time, which you select
with the arrow keys.
Press Settings (16) again to set a switch-off time. Proceed in the same way with the
setting
Delete settings
Press and hold the key (16) for 10 seconds to delete all previous settings.
Switch off
Press the on/off button. The heater will stop operating.
CLEANING
It is very easy to clean the back of the unit. To clean the back, hold the convector heater
by the sides with both hands and pull it forward.
After cleaning, put the heater back in place.
Storage
If you do not use the device for a long time, it is recommended to clean and store it
(preferably in the original box) in a cool and dry place.
21