IMPORTANT NOTES ON OPERATION
•
One remote control can be connected to several receivers at the same time
and thus operate several heaters.
•
All settings must be reset after changing or removing the batteries.
•
To use the weekly timer, make sure that the TIMER function has been switched
to ON by pressing the MODE button for a long time. If you prefer to operate
the heater manually, make sure that the TIMER function is set to OFF.
•
Do not cover or touch the temperature sensor located on the top of the
remote control.
•
Leave the remote control open in the room, do not put it in a drawer or bag,
under a pillow or blanket.
•
Replace all batteries with new ones immediately when the battery symbol
flashes on the display, otherwise the remote control will not be able to control
the heater.
•
Remove the batteries from the remote control if you are not going to use it for
a long time.
•
Please unplug the receiver from the power outlet if it will not be used for a
long period of time.
CLEANING AND CARE
Note: Turn off the unit and unplug it from the power outlet. Wait until the unit
has completely cooled down before cleaning it.
•
Use a vacuum cleaner to clean the ventilation slots and grilles.
•
Remove dust on the outside surfaces with a damp (not wet) cloth.
•
Do not use strong cleaning agents or abrasives.
•
Do not spray the device with liquids or immerse it in water or other liquids.
•
Never open the heater housing.
EN
43