Using A Blade - Shindaiwa C3410 Manual De Propietario Y Operador

Using a Blade C3410
WARNING!
n Before working with a blade-
equipped unit, always inspect and
clean the area of objects that could
interfere with or damage the blade.
n Never use a blade near sidewalks,
fence posts, buildings or other objects
that could cause injury or damage.
n Never use a blade for purposes other
than those for which it was designed.
n Whenever you strike a hard object
with a blade, always stop the
brushcutter and carefully inspect
the blade for damage. NEVER
OPERATE THE BRUSHCUTTER
WITH A DAMAGED BLADE!
n A blade-equipped unit must be
equipped with a bicycle-type handle-
bar or barrier bar as well as a har-
ness or shoulder strap.
n Always make sure the cutting at-
tachment shield is properly installed
before operating this unit.
Operating Units with a Blade
The blade rotates counter-clockwise. For
best performance and to minimize being
stuck by debris, move the blade from right
to left while advancing on your work.
Position the blade so cuts are made
between the blade's 8 o'clock and
10 o'clock positions (as viewed from
above). DO NOT cut between the 10
o'clock and 5 o'clock positions.
WARNING!
When cutting wood with a saw, feed
the blade slowly—never strike or "slam"
a spinning blade against the wood.
WARNING!
DO NOT use 2-tooth or non-Shindaiwa
approved 4-tooth cutting blades with
Shindaiwa trimmers and brushcutters.
Blade Thrust
'Blade thrust' is a sudden sideways or
backward motion of the brushcutter. Such
motion may occur when the blade jams or
catches on an object such as a sapling tree
or tree stump. BE CONSTANTLY ALERT
FOR BLADE THRUST AND GUARD
AGAINST ITS EFFECTS!
Brushcutter Handlebar
A brushcutter handlebar or barrier bar
helps prevent the operator from moving
forward, or the unit moving rearward, thus
preventing inadvertent bodily contact with
the blade. ALWAYS KEEP THE HANDLE-
BAR OR BARRIER BAR SECURELY IN
PLACE ON THE UNIT!
Brushcutter Shoulder Strap
A shoulder strap provides additional protec-
tion against blade thrust. In addition, a
shoulder strap gives significant support
and comfort to help ensure safe and ef-
ficient operation. When operating a C3410
with a blade, make sure both the handle
and shoulder strap are adjusted to the size
of the operator using the unit.
Ten
O'clock
Blade
Rotation
OK To Cut
Eight
O'clock
Figure 26
Vertical Cuts
Hold the brushcutter with the blade at
a 90° angle to the ground so the blade's
bottom edge rotates toward the operator.
Move the blade from top to bottom through
the cut, and cut only with the bottom edge
of the blade.
WARNING!
When making vertical cuts, never allow
the blade to exceed waist height.
Engine Operating Speeds
Operate the unit at full throttle while cut-
ting. Best fuel efficiency is obtained by
releasing the throttle when swinging back
after a cut.
n To prevent possible engine damage, do
not allow the brushcutter to run at high
speeds without a load.
n Avoid operating the engine at low
speeds. Doing so can lead to rapid
clutch wear. In addition, slow-speed op-
eration tends to cause grass and debris
to wrap around the cutting head.
Five
O'clock
Figure 27
Cut on the left side
of the blade. KEEP
YOUR BODY
OUTSIDE THE
PATH OF BLADE
ROTATION
13
13