Ff Door Pull; Gg Door Pull Bolt - Greentouch 2098FM-26-255 Instrucciones De Ensamblaje, Uso Y Cuidado

ASSEMBLY INSTRUCTIONS
8. I. Loosen the screws on the hinge arms and plates pre-attached on the walls (E and F).
II. Pick up left door (G) and attach it to left outer wall (E) by engaging both door hinges
simultaneously. Please follow the steps below to combine the door hinges together.
i. Extend both hinge arms on the left door (G) to open position.
ii. Insert the "J" hooks beneath the hinge arms into the lugs on mounting plates pre-attached on
left outer wall (E).
iii. Press lightly on the end of both hinge arms to engage the catch.
iv. To remove the hinge arms from the mounting plates, press gently in the release lever on the
back of hinge arms.
III. Once assembled, go back and fully tighten all screws.
IV. Repeat the same procedure to attach the other right door (H) at the opposite side.
V. Open and close the doors to make sure they are aligned and shut correctly. If necessary,
adjust the screws for a good fit.
8
E
G
9. Place door pull (FF) into predrilled hole on right door,
and secure with two door pull bolt (GG).
Repeat for remaining door pull (FF).
Hardware Used
FF
Door pull
GG
Door pull bolt
(CONT'D)
I
F
H
II
III
x 2
x 4
7
I/F
Release lever
(i)
(ii)
9
G
(iii)
"J" hook
FF
H
GG