Starting And Stopping - sunjoe GTS4001C Manual Del Operador

Fig. 10
Sprocket
8. Replace the chain/sprocket end cover by positioning the cover
onto the saw head. Tighten the end cover knob, but leave the
bar free to move for tension adjustment. Put back the hex bolt
by screwing it clockwise with the hex key wrench.
9. Remove all slack from the chain by turning the chain
tensioner ring clockwise until the chain seats snugly against
the bar with the drive links in the bar groove (Fig. 11).
NOTE: The chain is correctly tensioned when there is no
sag on the underside of the guide bar; the chain is snug,
but can be rotated by hand without binding. For more
information on chain tensioning, see the maintenance
section beginning on pg. 15.
Fig. 11
Chain/sprocket
end cover
Connecting to the Telescoping Pole
1. Open the assembly lock on the telescoping pole, and
push the chain saw head into the opening on the end of
the pole (Fig. 12).
Fig. 12
Telescoping pole
Adjusting pin
Chain tension
pin hole
Chain tensioner
ring
Chain saw head
Assembly lock
2. When the lock tabs snap in, lock back the assembly lock,
the pole chain saw will be ready to use (Fig. 13).
Fig. 13
Lock tab
3. To remove the chain saw head, release the On/Off switch
and remove the battery. Unlock the assembly lock. Push
the lock tabs on both sides, and pull the chain saw head
out (Fig. 13).
Operation

Starting and Stopping

1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 14).
Fig. 14
2. To turn the pole chain saw ON, push and hold the safety
lock switch (located on the handle) forward with your
thumb and then squeeze the On/Off switch with your
fingers. Once the tool is running, you can release the
safety lock switch (Fig. 15).
Fig. 15
3. To turn the tool OFF, release the On/Off switch (Fig. 15).
12
Assembly lock
Battery
Safety lock
switch
On/Off switch