sunjoe GTS4001C Manual Del Operador página 19

• Inspect the oil port and guide bar rails and clean them to
remove any debris.
• Check the chain tension.
• Check the chain teeth for sharpness.
• Check the bar and chain oil level; fill with only new chain
oil specifically formulated for chain saws.
NOTE: If you notice anything unusual, such as a vibration or an
odd sound, shut the saw OFF immediately. Remove the battery
and check the saw for any damage.
If you cannot find the cause of the problem or are uncertain
what to do, then have the saw inspected by an authorized
Snow Joe + Sun Joe dealer or call the Snow Joe
® ®
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) before using it.
m
CAUTION!
• Remove the battery and wait at least five minutes for the
saw to cool before servicing or storing your unit.
• If you drop the saw, carefully inspect it for damage. If the
guide bar is bent, the housing is cracked, the handle is
broken, or if you see any other condition that may affect
the saw's operation, DO NOT USE the tool. Instead, have
it serviced at an authorized Snow Joe
dealer or call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563).
Pole Leaf Blower
Assembly
m
WARNING!
To prevent serious personal injury, make
sure the battery is removed and the impeller has come to a
complete stop before attaching or removing tubes.
Attaching the Blower Tube
1. Inserting the blower head into the blower tube until the
blower tube lock tab snaps in (Fig. 31).
Fig. 31
Tube lock tab
+
®
+ Sun Joe
® ®
+ Sun Joe customer service
® ®
Blower tube
Leaf blower head
2. To remove the blower tube, push the tube lock tab while
pulling the tube away from the blower head.
Connecting to the Telescoping Pole
1. Open the assembly lock on the telescoping pole, and
push the leaf blower head into the opening on the end of
the pole (Fig. 32).
Fig. 32
Blower head
Telescoping pole
2. When the lock tabs snap in, lock back the assembly lock,
and the pole leaf blower will be ready to use (Fig. 33).
Fig. 33
Lock tab
3. To remove the leaf blower head, release the On/Off switch
and remove the battery. Unlock the assembly lock, push
the lock tabs on both sides, and pull the blower head out
(Fig. 33).
Operation
Starting and Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 34).
19
Assembly lock
Assembly lock