Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Release the buttons when the trimmer head is fixed into
the desired angle.
NOTE: Failure to properly secure the trimmer head may
result in personal injury and/or property damage.
m
WARNING!
Always ensure the hedge trimmer head is
securely locked! Do not attempt to use the pole hedge trimmer
with the head in any other position or unlocked!
Adjusting the Auxiliary Handle
The hedge trimmer is equipped with an auxiliary handle that
can be adjusted and removed. Follow the instruction below to
operate the auxiliary handle
m
WARNING!
Make sure the knob, bolt, and the screws
are fixed into place. Failure to lock any of them as directed
could result in personal injury or property damage.
To Remove the Auxiliary Handle
1. Disconnect the hedge trimmer from the power supply by
removing the battery from the compartment.
2. Unscrew the auxiliary handle lock knob and remove it and
the bolt, then the auxiliary handle can be pulled out
(Fig. 51).
Fig. 51
Bolt
3. Re-assemble the auxiliary handle lock knob and the bolt
on (Fig. 52).
Fig. 52
To Adjust the Position of the Auxiliary Handle
1. Disconnect the hedge trimmer from the power supply by
removing the battery from the compartment.
2. Remove the auxiliary handle lock knob, the bolt, and the
auxiliary handle. Use a screw driver to remove the two
screws that used to fix the auxiliary handle loops.
Remove the loops from the pole (Fig. 53).
Auxiliary handle
Auxiliary handle
lock knob
Fig. 53
Bolt
Auxiliary
handle loop
3. Re-assemble the auxiliary handle loop on the desired spot
on the pole by using the two screws, and put back the
auxiliary handle, the auxiliary handle lock knob and the
bolt (Fig. 53).
To Adjust the Angle of the Auxiliary Handle
1. Stop the hedge trimmer by releasing the On/Off switch.
2. The auxiliary handle can be adjusted in -45°, 0°, 45°.
Rotate the auxiliary handle lock knob to unlock the handle,
and then rotate the handle to the desired angle (Fig. 54).
Fig. 54
Auxiliary handle
lock knob
3. Rotate the auxiliary handle lock knob back to lock the
handle in position.

Before Operation

1. Check the tool, the battery as well as accessories for
damage before each use. Do not use the tool if it is
damaged or shows wear.
2. Double check that the accessories and attachments are
properly fixed.
3. Always hold the tool by its handle and soft grip. Keep the
handles dry to ensure safe support.
4. Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the tool.
5. Switch the tool off immediately if you are disturbed
while working by other people entering the working
area. Always let the tool come to a complete stop before
putting it down.
6. Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control
over the tool.
24
Auxiliary
Auxiliary handle
handle
lock knob
Auxiliary
handle loop
Screws

Publicidad

Tabla de contenido
loading

Tabla de contenido