Troubleshooting Tips; Troubleshooting Table - sunjoe GTS4001C Manual Del Operador

Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to
lay over sideways
• bent guide bar
• cracked or broken rails
• spread rails
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 30).
Do not mount a new chain with a worn sprocket or vice-versa.
Fig. 30
< 0.5 mm
Troubleshooting

Troubleshooting Tips

Most difficulties are easy to fix. Consult the troubleshooting
table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor
adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless chain saw.

Troubleshooting Table

Problems Corrective Action
The saw
•
Check that you have inserted the battery properly
motor fails
and the battery has enough power to work.
to start
•
Make sure that you fully depress, push forward
and hold the safety lock switch before squeezing
the ON/OFF trigger switch.
The saw
runs, but
•
The chain is too tight; re-tension.
the chain
speed is
low
Bar and
•
The chain tension is too tight; re-tension.
chain
•
running The chain oil tank is empty; refill.
hot and
•
The lubrication holes are plugged; clean them out.
smoking
The saw
motor
•
The chain tension is too tight; re-tension.
runs, but
•
The guide bar or chain is damaged; inspect
the chain
and replace the damaged part.
is not
turning
Daily Checklist, Cleaning
and Storage
Daily Checklist
To help maintain your pole chain saw for optimum
performance, we recommend you complete this checklist prior
to each work session.
m
WARNING!
Do not insert the battery until you have
completed all of the daily checks.
• Inspect for any visible damage to the chain, guide bar, or
motor housing.
18