sunjoe GTS4001C Manual Del Operador página 22

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Blow debris into a safe, open area away from children,
pets, open windows or freshly washed cars.
• Clean up after using leaf blowers and other lawn
equipment. Dispose of debris appropriately.
m
WARNING!
To avoid serious personal injury, wear
ear defenders, goggles or safety glasses at all times when
operating this unit. Wear a face mask or dust mask in dusty
locations.
m
WARNING!
To prevent serious personal injury or
damage to the unit, make sure the blower tube is in place
before operating the unit.
Air Vents
Never cover air vents. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
m
WARNING!
To avoid serious personal injury, do not
wear loose fitting clothing or articles such as scarves, strings,
chains, ties, etc., that could get drawn into the air vents.
To make sure long hair does not get drawn into the air vents,
tie back long hair.
Blowing Operation
• Hold the blower firmly with your dominant hand on the
unit handle and the other hand on the soft grip.
Sweep from side to side with the blower tube several
inches above the ground or floor (Fig. 43).
Fig. 43
• Slowly advance the unit, keeping the accumulated pile of
debris in front of you.
Maintenance + Care
1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done with
a rag or brush.
4. Never use caustic agents to clean plastic parts.
Troubleshooting
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless pole blower.
Problems
Corrective Action
Motor fails
Check that you have inserted the battery properly
to start
and the battery has enough power to work.
when switch
Make sure that you fully depress, push forward
is turned
and hold the safety lock switch before squeezing
on.
the ON/OFF trigger switch.
Pole Hedge Trimmer
Assembly
Connecting to the Telescoping Pole
The hedge trimmer head comes fully assembled. To use the
machine as a pole hedge trimmer, connect the hedge trimmer
head with the telescoping pole as indicated below.
1. Open the assembly lock on the telescoping pole, and
push the hedge trimmer head into the opening on the end
of the pole (Fig. 44).
Fig. 44
Hedge trimmer head
Telescoping pole
2. When the lock tabs snap in, lock back the assembly lock,
and the pole hedge trimmer will be ready to use (Fig. 45).
22
Assembly lock

Publicidad

Tabla de contenido
loading

Productos relacionados para sunjoe GTS4001C

Tabla de contenido