EGO CSX3000 Manual Del Usuario página 26

NOTICE:
Make sure that the direction
of the arrows on the saw chain teeth is
always facing forward (Fig.12).
6. Turn the tensioning screw clockwise
until the chain fits snugly against
the bar. Make sure the drive link
tangs engage the bar groove. The
guide bar and chain must be firmly
and securely mounted on the chain
saw (Fig. 13).
7. Set the kickback brake paddle to
position, align two guide rods of the
side cover assembly with their two
respective holes in the saw, then fit
the side cover assembly (Fig. 14).
8. Tighten the bar nut.
26
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
12
Locking Screw
Sprocket
13
14
Hole 1
Guide Rod 1
Hole 2
Guide Rod 2
Cutting Direction
Guide Bolt
Tensioning Pin
Tensioning Screw