If this is not necessary, the hob can be
turned on directly using
follow the operations below to access
the menu.
Before carrying out the procedure it is
advisable to read the entire paragraph.
Connect the hob to the domestic mains
power.
1. All the digits light up for a few
seconds, then switch off and only
keeps flashing.
2. Press and hold
cooking area indicate
3. While holding down
ing the zone digits, proceeding anti-
clockwise.
3
4
10. HOB FUNCTIONS
Child lock
Lock
10
, otherwise,
: the digits in the
.
, start press-
2
1
This function prevents accidental use of the appliance
To enable: if a pan is on the hob, press and hold the corresponding digit for 3 seconds. If there is
no pan on the hob, press and hold for 3 seconds one of the 5 digits (not visible) next to point
the left side. Release and slide your finger from 0 to 9 along the power bar which displays the oper-
ating sequence. All the digits indicate
The operations described must be completed within 10 seconds.
To disable: press and hold for 3 seconds one of the 5 digits in the cooking areas. Release and slide
your finger from 9 to 0 along the power bar which displays the operating sequence.
The operations described must be completed within 10 seconds.
It is possible to lock the hob functions during use, e.g. to clean the hob. The function is enabled
even if the hob is switched off and on again.
If the electricity supply is cut, the function is disabled.
To enable: press
and hold for 1 second.
To disable: press
.
The rear left digit indicates
number indicating the type of menu. The
front left digit indicates a number which
depends on the parameters indicated in
the selection.
Select the digit with
the power bar.
Select the front left digit and select the
correct setting.
See the following table for the specifica-
tions:
Notes
Value on the
KW
power bar
Standard initial setting
0
7.4
1
4.5
2
3.5
3
2.8
Once the correct value has been
entered, confirm by touching and hold-
ing
.
.
and a
and press "8" in
on